OM2000A+

4900 €
Frequency coverage :Amateur bands 1.8 – 29.7 MHz including WARC + 50 MHz
Power output :2000+ W in SSB/CW on HF bands, 1500 W in RTTY
1500 W CW/SSB on 50 MHz
Drive power :40 to 60 W for full output power
Input impedance :50 Ohm VSWR < 1.5 : 1
Output amplification :17 dB
Output impedance :50 Ohm unbalanced
Maximum output SWR :3:1
SWR protection :Automatic switching to STBY when reflected power is 350W or higher
Intermodulation distortion :better then -32 dBc
Suppression of harmonics :min -50 dBc (30–54 MHz better than -70dBc)
Response speed of AUTO tune :less than 0,5s within same BAND ,less than 3s if out of BAND
Supported TRXs-CAT :ICOM, ELECRAFT, KENWOOD, TEN-TEC ORION, YEASU,
Icom transceive protocol using by microHAM devices – CI-V OUPUT,
Flex Radios and Anan ( Apache Labs )
Tube :FU-728F ceramic tetrode
Cooling :Centrifugal blower + axial blower
Power supply :Switchable 220,230,240V – 50/60 Hz or other primary voltages
(for example 200V 50/60Hz for Japan)
Transformers :1 toroidal transformer 3.0 kVA
Protection circuits :- VSWR too high
 - Anode current too high
 - Anode voltage error
 - Screen current too high
 - Screen voltage error
 - Grid current too high
 - Grid voltage error
 - Heating voltage error
 - Mistuning of power amplifier
 - Temperature to high
 - Soft start for fuse protection
 - “switch –on blocking“ at opened amplifier
Indications :4.3" colour touch screen display
Features :- Automatic external Antenna switching
 - Automatic switching between bands
 - Automatic tuning within the band according to segments
 - Automatic switching of Band Pass Filter
 - Memory for faults and warning, easy maintenance
 - Automatic set-up anode current (BIAS) – no need to manual adjust after changing the tube
 - Three programmable working modes of centrifugal blower ( turbine ) + axial blower
 - T/R System : QSK operation with built-in vacuum RF antenna relay
 - Easy transport due to detachable HV transformer
 - Remote control - connector for LAN connection
 - The Power Amplifier is HF sensitive (automatic frequency reading even if no CAT)
 - The smallest and lightest 2000 W automatic PA on the market
Mechanical parameters :390mm x 195mm x 370mm (width x height x depth)
Weight :24 kg